jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
Breaking the car for spares as new project is up and need cash badly.
20XE "G reg engine 1989 non cat model" 2.0 16v 156bhp
Complete with Manifolds, F20 Gearbox, SFI box, Wiring loom and ECU
in excellent condition, all was stripped prior to fitting to ensure reliability.
Very solid engine ready, no smoking or losing water.
£offers
Motorsport Spec Harry hockley chrome finished Driveshafts 1.5" thick for bigblock corsa conversion with bigblock CV joints (reconned) and Bigblock hubs with new wheel bearings in knuckles in superb condition - less than 100miles use
£offers
Engine, Gearbox and antirollbar mounts for 2.0 conversion
also in superb condtion under 100miles use.
£offers
Apex motorsport spec heavy duty shocks with -60mm high poundage motorsport springs, front and rear set complete.
£offers
Vauxhall 2.0 16v 4 stud 256mm brakes with brand new pads
ive got two sets of these
£50 a set ono
3 radiators, 2.0 spec complete with fan
£10 each
Corsa rear disc conversion setup, fully overhauled brakes, ready to go, just need nova handbrake cable to finish it.
£offers
C20NE 115bhp 8v engine, with ecu , f16gearbox, and wiring loom
Good solid engine no smoking at all
£offers
Many other bits too, will add as i can remember them.
[Edited on 16-11-2003 by jjcymru]
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
also have a shed full of other corsa mechanical parts to shift
|
oztek corsa
Member
Registered: 31st Jan 03
Location: luton
User status: Offline
|
r u selling the 16v? and how much do u want for the 8v? whats the meilage on them?
|
BeArDy
Member
Registered: 7th Aug 00
Location: Manchester
User status: Offline
|
Corsa rear disc conversion setup, fully overhauled brakes, ready to go, just need nova handbrake cable to finish it.
£offers
you have U2U m8ty i want
|
Karnage Corsa
Member
Registered: 4th Nov 02
Location: Norton, Stockton-on-Tees
User status: Offline
|
so do I
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
All pm's replied lads
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
both engines are at 100k and theyre very good condition
the 16v's block has been cleaned out and painted and looks mint, the engine pulls extremely well and will do another 100k if serviced properly.
Has a new set of plugs and oil/filter change 30miles ago.
£500 for the 16v with box, ecu ,loom
£100 for the 8v with box, ecu and loom
|
DanJ
Member
Registered: 8th Aug 03
Location: Guildford
User status: Offline
|
u2u sent
|
whitter45
Member
Registered: 15th Nov 02
Location: Norton
User status: Offline
|
u2u sent mate
|
kz
Member
Registered: 9th Aug 02
Location: Southend, Essex Drives: Mini Cooper S
User status: Offline
|
i take it the 8v wont fit _straight_ into a corsa b? it will need proper fitting i.e. expensive right?
|
jjcymru
Member
Registered: 28th May 02
Location: ammanford,south wales
User status: Offline
|
alll u2u's replied
the 8v and 16v share the same bottom end and very similar gearbox and therefore require an almost identical fitting setup.
But at that cost you could do the conversion urself with a pvd kit and drive away £600 spent, not bad eh.
|
whitter45
Member
Registered: 15th Nov 02
Location: Norton
User status: Offline
|
several u2u's sent mate and emails also
|
Underwood
Member
Registered: 7th Sep 01
Location: Hull & Manchester
User status: Offline
|
how mch for all the things i need for a 2.0l 16v engine etc
|
whitter45
Member
Registered: 15th Nov 02
Location: Norton
User status: Offline
|
take it u don't to sell anymore mate
|