ado
Member
Registered: 19th Oct 03
Location: Chesterfield,midlands
User status: Offline
|
Hi modders!
Just done conversion but the exhaust is catching on the anti roll bar at front.
Any one heard of this or had this prob,how you get round this?
Its not just that the bar not in correct position?
Anyone got measure ments of were it should be if this is the case?
Cheers chaps and chocks away!!!!
|
p16vlv
Member
Registered: 15th Jun 02
Location: rossendale
User status: Offline
|
put spacers on anti roll bar . i think mine is about 20mm lower than normal.
|
ado
Member
Registered: 19th Oct 03
Location: Chesterfield,midlands
User status: Offline
|
yep have put the spacers on that have come with the conversion kit but still seems to catch.
They are alloy blocks.
|
p16vlv
Member
Registered: 15th Jun 02
Location: rossendale
User status: Offline
|
your engine isnt sat at too much of an angle is it. if you look at the engine from the front of car , you can see where the slampanel runs ,your rocker cover gasket should run parallel to this , and be about 20mm above the line of the slampanel.
|
ado
Member
Registered: 19th Oct 03
Location: Chesterfield,midlands
User status: Offline
|
Dont think it is,but say it was how would i be able to alter this?
|
p16vlv
Member
Registered: 15th Jun 02
Location: rossendale
User status: Offline
|
check your engine mounts are ok .
|
