StuartyB
Member
Registered: 14th Jan 04
Location: Lisburn
User status: Offline
|
was wondering is it possible 2 cut away any plastic at the back of where the headunit wud b as with the amount of wires coming out of the back of the Hu the HU wont fit down in properly and keeps bouncing back out any help????
|
Trucido
Member
Registered: 14th Jun 03
Location: Bristol
User status: Offline
|
it will fit you have to play around with it...you just got a headunit and normal wires there?
|
Carb_Fanatic
Member
Registered: 5th Jan 04
Location: South East
User status: Offline
|
if the corsa in question is a corsa B then it will fit. basicly, the factory HU has a cage which goes around 5 sides of the HU instead of the normal four. this cage needs to be removed totaly by undoing the bolt holding it to the car at the very back of it( you can do this after the unit is out the cage). then the metal which the old cage bolted onto can be bent slightly back if you are having problems with clearance. or using your fingers it is possible to get the ISO conector plugs down the back of the metal strut so that you can possition them by putting you hand in under the glovebox.
the hardest thing i found was making sure the aerial stayed on. i had to remove the ash tray, ( 4 cross head srews and a wiring plug) and then attached it as i put the unit in.
hope some of that may be of use.........
|
StuartyB
Member
Registered: 14th Jan 04
Location: Lisburn
User status: Offline
|
it is headunit normal wires power wire as it is alpine and 3 sets of rca
|
mjw_2k2
Member
Registered: 18th Sep 03
Location: Anglesey, North Wales
User status: Offline
|
unno the metal bar where you can bolt the HU onto? get all the wires behind that then it will be easier to fit in, bit fiddly but it is possible
|