mossy
Member
Registered: 22nd Jan 04
Location: Manchester Drives: GSi
User status: Offline
|
how hard is it or costly and whats involved?
|
kerzo
Member
Registered: 10th Nov 02
Location: Norn Iron
User status: Offline
|
get the angle grinder out yourself
|
mike16v
Member
Registered: 20th May 02
Location: sheffield, yorkshire
User status: Offline
|
needs cutting out, then a metal plate welding in and needs sealing properly at both sides
|
mossy
Member
Registered: 22nd Jan 04
Location: Manchester Drives: GSi
User status: Offline
|
is it that simple? wont ne thin need strenghtinin etc?
|
mossy
Member
Registered: 22nd Jan 04
Location: Manchester Drives: GSi
User status: Offline
|
anyone actually done this and can give me advise
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
few people have had it done, but like said here, just a case of cutting it out & then using something like 3-5mm sheet steel & weld it in place & seal it.
no need to strengthen anythin
|
mossy
Member
Registered: 22nd Jan 04
Location: Manchester Drives: GSi
User status: Offline
|
ok, cheers paul 
(and others)
|