Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Right the blue corsa wont go into reverse. Its a 1.2 8V
I have tried resetting the gear linkage twice & that hasn't worked. Also when in neutral or any other gear it is very sloppy & the gearstick can be moved about quite alot
Any help on this would be much appreciated
Matt
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
is the bolt on the clamp bit under the car tightened up properly... i had this it was like stirring soup till i tightened everything up nice
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Yep its definatley tight. Was done after I reset the gear linkage.
Anyone else any ideas?
|
BromleyBoy
Member
Registered: 5th Apr 03
User status: Offline
|
did you correct the gear linkage in the right place,gear lever held to the side and box in neutral? lift the gear gaiter up and make sure it goes far enough left and the lift reverse works
|
linz
Member
Registered: 18th Jun 04
Location: Co Durham
User status: Offline
|
the linkage on top of the gear box is bad for wearing, sounds like wear and tear
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
It goes into the positon for reverse on the gear sticjk but it seems to select 1st or 3rd
Just a pain in the ass as I cant drive it to a garage
|
AdamF
Premium Member
Registered: 24th Apr 02
Location: Bexhill, East Sussex
User status: Offline
|
can you get fifth? normally if youve set the linkage too far over so you get first in reverse you wont beble to get fifth cos it wont go over far enough
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
I will try this Adam. Thanks
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Offline
|
Put it in first position and have someone hold it there, get under the car and loosen the linkage bolt and hold the linkage, then have them put it in third then tighten it up.
If you're getting the gears but in the wrong places ie. to the left or right of where it should be then its just a linkage problem and should be easy to sort.
|
Siberia
Member
Registered: 9th Oct 03
Location: Leprechaun Land Drives : Zafira GSI
User status: Offline
|
are you positively certain you reset the linkage right? its either that or a fecked linkage....
when i done my conversion i didnt tighen up the clamp bolt right and lost reverse in rush hour traffic... no biggy but then i lost 1st and 2nd yay the fun of driving 9 miles with 3rd and 4th gear and every cnuting traffic light being red.. fecked the clutch good and proper....
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
i have a spare linkage for the gearbox top
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Cheers guys
|