alistairolsen
Member
Registered: 21st Jan 06
Location: glasgow
User status: Offline
|
hi, I have a late corsa 1,2 which had a dispak engine. Ive recently fitted an xe to it.
Ive got one vac pipe (plastic small bore pipe with a rubber end) which doesnt fit anywhere. It coes thru the bulkhead by the master cyl, fuel pipes, throttle cable etc as far as I can see and runs along the back of the inlet manifold.
SAomeone has suggested its a fuel tank vent pipe? Where should it be connected to? AFAIK theres a valve for it on the end of the block by the DIS unit?
|
Lisa
Member
Registered: 6th Apr 00
Location: Euxton, Lancashire
User status: Offline
|
leave it tied up at the back .
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
mine is connected to the sensor which is near the dispak
|
Lisa
Member
Registered: 6th Apr 00
Location: Euxton, Lancashire
User status: Offline
|
is it the pipe ,bottom right next to the earth lead.
|
alistairolsen
Member
Registered: 21st Jan 06
Location: glasgow
User status: Offline
|
yeah, buut the rubber bit on mine is straight, not a right angle bend.
Concensus is it wont do any harm if its not connected?
|
Lisa
Member
Registered: 6th Apr 00
Location: Euxton, Lancashire
User status: Offline
|
mine isnt and it creates no problem.
|
CoastalCorsa
Member
Registered: 7th Jan 05
Location: Lancashire
User status: Offline
|
no its only a vent pipe my brake servo pipe has a scre in it where there is a lump in the pipe an a small pipe coming from it
|
craig_s
Member
Registered: 5th Mar 06
Location: Birmingham Drives: mk4 astra gsi
User status: Offline
|
is it a small red pipe if so it goes on the air box.but u can leave it off.if not its probably the 1 that goes on ur vaum pipe for the master cylinder.
|
