shane2corsa
Member
Registered: 4th Sep 05
Location: Nettleham, Lincolnshire
User status: Offline
|
Anyone know the recommended torque setting for the above?
its a 1.1i with 3 stud hubs
|
shane2corsa
Member
Registered: 4th Sep 05
Location: Nettleham, Lincolnshire
User status: Offline
|
up up please help someone
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
ask on a saxo site maybe
|
shane2corsa
Member
Registered: 4th Sep 05
Location: Nettleham, Lincolnshire
User status: Offline
|
im not sure of any what are any good?
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
but on most cars its a case of tightening the nut on the end of the shaft while rotating the bearing to settle it in. tighten it so that it just 'nips' then then slacken off slightly until the retaining pin can be inserted through the hole in the shaft. dont tighten it to get the pin in the hole, always slacken it.
|
shane2corsa
Member
Registered: 4th Sep 05
Location: Nettleham, Lincolnshire
User status: Offline
|
hmm i think thats how it will have to be, though unlike the corsa rear bearings which are taper ones, the front one on this pile of poo seems to be a sealed unit which is held in with a circlip. ill just use my judgement me thinks.
|
ricky1989
Member
Registered: 3rd Apr 06
Location: Langney, East Sussex
User status: Offline
|
google "saxperience" first link mate, is da best
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
5 diga diga's of the windy gun!
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|

http://www.saxosportsclub.com/forum/
|
vaux-tech
Member
Registered: 28th May 06
Location: Preston, Lancs. Drives: Astra SRI turbo.
User status: Offline
|
FT- FECKING TIGHT, I LIVE BY THAT SAYING!
|
shane2corsa
Member
Registered: 4th Sep 05
Location: Nettleham, Lincolnshire
User status: Offline
|
done the bearing it was 250nm, i used the garages autodata book. but...... the ferkin thing still wobbles!!! help? anyone?
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
sure its the right bearing?
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
go for the drive shaft there is a 3stud shaft and a 4stud shaft
|