Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
i have a elec spreedo sender, has a worm gear on the bottom and a 3 pin plug socket on it
would that work?
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
yep
|
DaNnY_LaD
Member
Registered: 30th Nov 05
Location: Walkden,Manchester
User status: Offline
|
Would it?
you sellin it adam?
|
DaNnY_LaD
Member
Registered: 30th Nov 05
Location: Walkden,Manchester
User status: Offline
|
ttt
|
DaNnY_LaD
Member
Registered: 30th Nov 05
Location: Walkden,Manchester
User status: Offline
|
Any luck adam?
|
dja
Member
Registered: 16th Nov 02
Location: Bolton,lancs
User status: Offline
|
Ive just done this today.
I replaced an X16XE/F15 with an X20XEV/F20.
The F15 was a hall sensor which read from a ring with holes in it.
The F20 was the standard worm drive/cable affair.
Although the F15 hall sensor fits it doesnt pick up a signal from the gear drive on the F20.
The way i got round it was to get hold of a set of cable driven corsa clocks along with the cable and used the worm drive allready fitted to the F20.
I got the clocks fom the scrappy for £20.
Dave
|
dja
Member
Registered: 16th Nov 02
Location: Bolton,lancs
User status: Offline
|
quote:
Originally posted by Adam-D
i have a elec spreedo sender, has a worm gear on the bottom and a 3 pin plug socket on it
would that work?
It depends how many pulses it gives per wheel revolution,the F15 gives 29 or 30 pulses per wheel (diff) revolution,if your sensor gives more pulses or less pulses the speedo will work but will be way out.
I think the sensors used for an astra digidash are no where near enough pulses per wheel rev.
Dave
|
DaNnY_LaD
Member
Registered: 30th Nov 05
Location: Walkden,Manchester
User status: Offline
|
Ok thanks...
Well i need to knw what to buy here lads...ive got a 1998 corsa 1.4 sport oringal....I would like to keep my clocks ive got atm ...If anyone has all off the following give me a shout?
|
DaNnY_LaD
Member
Registered: 30th Nov 05
Location: Walkden,Manchester
User status: Offline
|
Adam D has got the plug and no wirers...DO I NEED THE WIRERS?
|
Rick Draper
Member
Registered: 10th Feb 01
Location: Cheshire
User status: Offline
|
Right. Looking at my sport loom i can only see one round connector on the engine bay loom. Its only got 2 wires going to it though a black and a black/white. Is it a round connector i am looking for? Is it in the same loom as the lights or the same one as the starter motor and alternator etc? If its the starter motor lot has anyone got one of those looms they want to sell me??? Please!
[Edited on 01-01-2007 by Rick Draper]
|
Rick Draper
Member
Registered: 10th Feb 01
Location: Cheshire
User status: Offline
|
Bump. Anyone there?
|
