jamied
Member
Registered: 27th Oct 03
Location: Marbella,Spain Drives: C63
User status: Offline
|
http://www.migweb.co.uk/forums/vauxhall/mechanical-electrical/292546-someone-help-car-going-if-i-cant-sort.html
|
Basscrazy
Member
Registered: 16th Sep 05
Location: If im on here then clearly in front of the pc
User status: Offline
|
fuck me this list is getting huge
|
Basscrazy
Member
Registered: 16th Sep 05
Location: If im on here then clearly in front of the pc
User status: Offline
|
list now
trace cts wire see if its broke
check throttle body see if sticking
check throttle position sensor
oil change
engine flush
|
Basscrazy
Member
Registered: 16th Sep 05
Location: If im on here then clearly in front of the pc
User status: Offline
|
anyone think of anything else also really need to know which jobs are easy and which are hard
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
I know the clip on the end of the CTS wire that goes onto it isnt the best. Can you do some sort of check to see if a wire is broken inside at all, sure there is a name for it......
Stick at it mate, i had problems with my valver, took me two weeks off work to sort it, damn thing!
Is your EM light wired up, if so i take it your getting no faults......
|
Basscrazy
Member
Registered: 16th Sep 05
Location: If im on here then clearly in front of the pc
User status: Offline
|
been told it is wired up properly yea beardy did the conversion so was done proper
when you say the wire you mean ecu side or block side
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Well on the CTS, there is a clip that goes over the rounded end, well you just push it on, i know mine was pretty rusty, so i just got some emery paper to it.
As for the wire does it clip into another connector like the crank shaft sensor does or will it go straight back to the ECU........i cant remember.
I'm sure an elecy must be able to do some sort of test from end to end on the CTS wire........
Other options are, try a different ECU......mine got water it it as it wasn't sealed properly in the bulkhead! Or there is a slim chance one of the sensors you've replaced is still dodgy.
|
Basscrazy
Member
Registered: 16th Sep 05
Location: If im on here then clearly in front of the pc
User status: Offline
|
ecu is inside the car
cant think which sensor to try i could keep changing and it could be nothing to do with that
wire clicked into sensor very tighley was very good
lambda wire has bit worn through but dont think it would cause any of this
|
Basscrazy
Member
Registered: 16th Sep 05
Location: If im on here then clearly in front of the pc
User status: Offline
|
also could alternator effect anything as that screams a bit sometimes
|
Gregor
Member
Registered: 28th Nov 03
Location: Paisley, Renfrewshire
User status: Offline
|
It could be a shitload of things mate but take your time an be patient.
5 months after my conversion I am only just finishing ironing out problems !
|
Basscrazy
Member
Registered: 16th Sep 05
Location: If im on here then clearly in front of the pc
User status: Offline
|
true
i put a different afm in and it died all the time
put my old old one back in and only dies once or twice on start up im starting to think it may be this combined with lambda????
|
