Poot
Member
Registered: 30th Jan 05
Location: Wales/midlands drives: 1.6 16v
User status: Offline
|
Hi all,
I've started to strip down and rebuild the x16xel engine I have,(Only a matter of time now jas ) jst looking round for the cost of parts, cant find much on it?
Basically i'll need a new full gasket set, new set of piston rings, and possible pistons too. do bepco do these parts for car engines? prices?
Also...anyone got a ballpark figure for lightening and balancing the crank/bottom ends?
much appreciated
[Edited on 29-01-2007 by Poot]
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
you got to ask your self, it it worth it?
i asked today, looking at over £100 for rings, £80 for shells, then pistons and a rebore (vauxhall only sell oversize pistons now 0.5mm)
would be cheaper to buy a second hand engine, by about half the price
|
D41EOS
Member
Registered: 18th Jun 06
Location: nr carlisle
User status: Offline
|
hiya im a mechanic and it cost me £117 through work for rings alone... i know tms does rings and a head set not sure but i could be the same as the x16xe and c16xe
|
Poot
Member
Registered: 30th Jan 05
Location: Wales/midlands drives: 1.6 16v
User status: Offline
|
Fook me...£100 for rings?? there are only 3 on each piston 
UPDATE got the pistons out via taking big ends off, and the psiton rings are all fine, yet the measure the exact ring end gaps, but all look fine 'n dandy, as do the bores.
Any idead as to cause of the problem? Was burning oil like hell on start up, lots and lots of blue smoke, seffo burning it. Valves (inlet) coated in oil, also inlet and throttle butterfly all floating in oil, as were the injectors.
Valve stem seals anyone?
|
