Kurt
Member
Registered: 23rd Oct 05
Location: Hi
User status: Offline
|
Im considering converting the corsa to a 2.0.
Now theres a few tatty bits in the engine bay id like cleaned up aswell as a strengthening kit fitted.
If i remove the rad, original engine, gearbox and shafts etc can i still roll it on the wheels and hubs?
Pretty much i'd like to strip the bay and get it sent off to have the work done.. would it be ok or would the bearings, hubs, flanges colapse?
|
Kevxx
Member
Registered: 14th May 08
Location: Forfar, Angus
User status: Offline
|
you can run them on the standard hubs i believe, but better for stronger one's ..and wheels remember you'll want brakes 
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
yes you can still move it about just build the front up without the driveshafts in
|
Kurt
Member
Registered: 23rd Oct 05
Location: Hi
User status: Offline
|
Cheers Daz 
was worrying that without the hub nut they fall out 
its literally just to get it on a wagon to get it to somewhere to have the bay cleaned up and strengthened
|
DAZ1985
Member
Registered: 3rd Sep 06
Location: Scholar Green, Cheshire
User status: Offline
|
|
bieransri
Member
Registered: 13th Apr 06
Location: Kidsgrove, Staffordshire
User status: Offline
|
if its rolled around alot the bearing can collapse. since you'll be using conversion hubs and cv joints,
take the outer cv joint off the shaft. and bolt it in the hub asif it were the whole driveshaft. can just spin freely then
|
Kurt
Member
Registered: 23rd Oct 05
Location: Hi
User status: Offline
|
it doesnt matter anyway now.. just gonna sell it
|
