Steveocee
Member
Registered: 19th Jun 08
User status: Offline
|
OK, following on from my other thread i'm still having no luck,
I've made a pin to sit in where the clocks go, and i've run a wire down to the ecu, i'm tripping over at this point though. I've tried now about 3 different green cables, one of which was thicker than the rest and solid green and i got nothing from it.
So i've included pictures, if someone could just point out which plug would be a start as i'm getting frustrated now as i can't find the correct wire.
I tried the solid green in the middle of the left block on this and didnt get anything, may have been right and i've missed something.
In this there is a green that goes up to one side of the connector and is not continued, but this didn't have any effect on the rev counter either.
I promise i'll stop pestering people once i get this sorted
|