c20kenny
Member
Registered: 12th Jun 08
Location: Cumbria
User status: Offline
|
basicly put it in gear let clucth out nothing happens clutch plate has plenty of life on it. but thurst bearing has gone.could this be the course of the problem.also carn't get revese but took selector off the top off the box used a screw driver to move selector inside the box whent in fine. any ideas
|
Ellis
Member
Registered: 11th Sep 07
Location: Aberdeenshire
User status: Offline
|
Does it stall when you engage the clutch?
|
c20kenny
Member
Registered: 12th Jun 08
Location: Cumbria
User status: Offline
|
no it just makes alot of noise
|
Torsa g
Member
Registered: 20th Sep 07
Location: Tamworth. Rides: An OSTRIDGE
User status: Offline
|
shafts in properly if not its time to replace the release bearing
|
--ToM--
Member
Registered: 23rd Nov 07
Location: Wirral
User status: Offline
|
sounds like release bearing pal
|
c20kenny
Member
Registered: 12th Jun 08
Location: Cumbria
User status: Offline
|
just took the gearbox off and cluch out to check if all was right. and noticed the bit of the clutch that goes over the splines on the input shaft were way to big. i could spin the plate without moving the shaft. so i take it i have the clucth for an f28 and i need one for an f20.
[Edited on 13-02-2009 by c20kenny]
|
