shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
hello all im shortly going to start rebuilding my C16XE lump and was thinking of the head to be machined is there anything else i could do other than
Cams
Port & Polish
Gas Flowed
3 Angle Valves
im having a 4 branch and power box and was thinking of having the TB enlarged is there anymore i could do whilst it gets machined??
cheers
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
Get pistons pocketed for higher lift cams?
Get ARPs fitted so you can raise the rev limit for cams and power box?
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
264 cams but iirc philip2 said you can run 270 cams with geting the pistons pocketed more.. as the pistons on the xe engines are pocketed.
gas flowing well thats a bit of a shit to do as reading up on the sbd site the x16 and c16 heads cant be re moddled effectivly due to there origenal casting design and they recomend getting the later z16 head (square ports) as this offers a better ability to gas low..
if you can find a place to do the gas flowing and port and pollish then your laughing.
oh and 3 angled valve ou should get that as standard when having valves lapped in at a machine shop. all it does is make a better seat wont get any more power from it.
but having a powerbox fitted and having a 4 branch mani.. which one is it a 4-1 or a 4-2-1?
but arp rod bolts are a must if you are wanting to rase the rev limit. cant rev the engine over 8k tho as standard rods will break so a remap to 7.5 or 7.8 wil be what you need
|
philip2
Member
Registered: 1st Oct 06
Location: n.wales/chester
User status: Offline
|
Im on mobile at moment. Bt u2u me what there qouting on the head work, could see if can do it abit cheaper for you.
For less hassle stick with the c16 head. Get pistons pocketed 2mm deeper and if stil on stock ecu, 278 is about the largest cam that should just about work (have lumpy idle) then get bottom end lightened and balanced, and id stay at 7.5k peek rpm and obv fit arps.
|
shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
where could i get my pistons pocketed? and phillip2 ill pm u now mate
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
Pritie sure phill can do that as well fella
|
philip2
Member
Registered: 1st Oct 06
Location: n.wales/chester
User status: Offline
|
i can get them done, but not 100% sure what it would cost.
but i do know SBD did do them, not sure if still do though, might be worth a try?
|