jamesy1990
Member
Registered: 15th Dec 08
Location: fife
User status: Offline
|
hey all , recently rebuild my x16xe just finished putting the engine back in but the issue is it wont turn over , i turn the ignition im getting dash lights i can hear the pump starting and all my relays click but it wont crank , i have wired the posative from the starter to the posative terminal and the earth to the nagative , iv got a posative from my altenator going to the posative terminal and that little blue wire is also attached to the altenator as far as im aware the starting and charging loom is wired correctley ,
any advice will be greatly appreciated
|
jamesy1990
Member
Registered: 15th Dec 08
Location: fife
User status: Offline
|
anyone?
|
Scotty C
Member
Registered: 6th Nov 05
Location: Kidderminster Drives: 1.6 16v Sport
User status: Offline
|
Tried bumping it?
|
jamesy1990
Member
Registered: 15th Dec 08
Location: fife
User status: Offline
|
nah no yet mate its still a foot off the ground , took the starting and charging loom off for a closer inspection looks like i have fried the live going to the starter so im thinking i may have burnt the starter out ,
had a go at removing the starter motor and the top bolt is so akward to remove dont know how im gona manage
[Edited on 11-05-2010 by jamesy1990]
|
barter
Member
Registered: 27th Oct 07
Location: essex
User status: Offline
|
get the kettle on,drink the cuppa.if you smoke spark a fag. once finishd the to main steps try and get if off again and it normally comes off alot easyier.
|
jamesy1990
Member
Registered: 15th Dec 08
Location: fife
User status: Offline
|
that sounds like a plan my friend , been through alot of fags with this rebuild !! haha
|