pandamoanium
Member
Registered: 15th Apr 02
Location: London : Corsa GSI 16v
User status: Offline
|
Is it easy to change the bulb/s on the middle console where the fan etc are. Mine have been blown since i got the car and saw somebody with theres working and it really makes a difference. Any ideas ??
|
Foz
Member
Registered: 8th May 02
Location: Bristol
User status: Offline
|
have fun thats all i can say!
|
pandamoanium
Member
Registered: 15th Apr 02
Location: London : Corsa GSI 16v
User status: Offline
|
So i assume it is not easy from the amount of response i have received ??
|
Jason Iles
Member
Registered: 19th Jun 01
Location: Bristol
User status: Offline
|
Really easy I did mine on my old Corsa B using a trusty Haines Manual
[Edited on 26-03-2003 by J 11ESY]
|
pandamoanium
Member
Registered: 15th Apr 02
Location: London : Corsa GSI 16v
User status: Offline
|
Thanks will try get my hands on a haines manual... Then hopefully will be as easy as said, than done....
|
cobra148
Member
Registered: 27th Oct 01
Location: Here in front of my monitor.....
User status: Offline
|
Take a look on FAQ's theres a post there.
If you have a GSI it won't be too difficult. I've done 3 early model B's with no problems, later ones are a bit more difficult.
|
pandamoanium
Member
Registered: 15th Apr 02
Location: London : Corsa GSI 16v
User status: Offline
|
Thanks very much...
|
KITcorsa
Member
Registered: 16th Dec 02
Location: Middlesbrough
User status: Offline
|
apparantly its piss easy! i just ordered some blue leds instead of the white light and been told its easy! just remover the slider button the ply off the cover behind that to revel to screws, take then out, the the top air vents flip them down then with a screw driver ply then down thurther then that flip normall and that click down to reveal 2 more screws! ondo them and the console just pulls out! dosen't pull out to far though due to wires! then all you need to do is remove the white plastic behind, eather screws or clips depending on age and model and the bulds are just there! easy! good idea to remove all three turn nobs and remove the facure and spray it or fit carbon fiber at this time as it will save you having to remove it all again! hope this helps!
|