sparcost3
Member
Registered: 21st Sep 09
Location: Stafford, Staffordshire
User status: Offline
|
hi guys just had my wheels refurbed and obviously the powdercoating went down the thread on my cesaros and me being an idiot forgot to run a tapping tool down the thread to clear out all the crap and now ive got the bolts half stuck so there centre caps rattle around and i cant do anything to get them on or off O_O
they tool with the 3 pins snapped :/ and also destroyed some long nose pliers..
any ideas lmao :S
cheers, ste
|
sxibeast
Member
Registered: 6th Aug 03
Location: Milton Keynes
User status: Offline
|
Squirt some penetrating fluid onto the reamaining thread of the screws and down the hole as best you can!
Depending how far down you have the bolts, you could try a hammer and punch and gently tap them round, if not drill the head of the bolts off, then carefully cut a slot into the top of the remaining shaft and use a flat blade screwdriver to undo or if you can file a couple of flats onto the shaft, you can then use an adjustable spanner to undo.
Make sure you cake the bolts in fluid though!
|
sparcost3
Member
Registered: 21st Sep 09
Location: Stafford, Staffordshire
User status: Offline
|
nice 1 mate ill go give it a go!
|
sparcost3
Member
Registered: 21st Sep 09
Location: Stafford, Staffordshire
User status: Offline
|
cheers mate, worked a treat! much apriciated!
|
sxibeast
Member
Registered: 6th Aug 03
Location: Milton Keynes
User status: Offline
|
No problem!
|