Johnjourno
Member
Registered: 10th Sep 12
Location: Middlesbrough
User status: Offline
|
Hi everyone, I was at the breakers yesterday getting a car loom so I can fit electric windows etc, got the loom upto the multiplug at the front, do I need the dashboard loom to run it? The loom I have sourced has the CDL controller on it, and all the wiring to the doors, and I got the door looms, but do I need the dash loom, as none of my wiring went to the fuse box, or is the dash loom the same? To my next question, is the fusebox/relay board different on the EPS cars to the non EPS? if so, I presume I need the dash loom, I am guessing I don't need the headlamp loom as it won't be any different than mine, and hopefully it doesn't require me removing the engine loom?
Any help would be great!
|
Johnjourno
Member
Registered: 10th Sep 12
Location: Middlesbrough
User status: Offline
|
Forgot to add, I removed the 2 bolts from both sides of the dashboard, the bolt behind the centre console and removed the support bar, and the 2 nuts on the drivers side next to the fusebox but it won't come out, have I missed something obvious?
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
There's mre bolts inside the engine bay
|
scottyp1989
Member
Registered: 29th Jul 07
Location: Warley, West Midlands
User status: Offline
|
Under the scuttle pannel
|
Johnjourno
Member
Registered: 10th Sep 12
Location: Middlesbrough
User status: Offline
|
anyone got a picture of this? or a link to a guide? are these the only bolts left to remove?
|
Johnjourno
Member
Registered: 10th Sep 12
Location: Middlesbrough
User status: Offline
|
don't worry now, managed today
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
Welcome
|
