tomcorsa
Member
Registered: 11th Nov 02
Location: London/kent
User status: Offline
|
az abuv!!
|
Gambit
Member
Registered: 5th Jun 00
Location: Common Sense HQ
User status: Offline
|
yea, but you'll need an adapter to accomodate the difference in the bore
most exhaust garages will be able to fit it for you
|
tomcorsa
Member
Registered: 11th Nov 02
Location: London/kent
User status: Offline
|
iz the 1.2 bore bigger or smaller i take it its bigger cheerz m8
|
and-m
Member
Registered: 5th May 02
Location: Liverpool. Drives. Skud vRS.
User status: Offline
|
Bigger...the 1.0 12v exhaust bore is small...
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
the 1.2 backbox will be a matter of mm's bigger than your 12V exhaust system.
So, you have two options that i can think of:
1. Buy and fit an adaptor pipe (not t0o sure where from)
or
2. Cut an extra slot on the end of the backbox pipe. So when you tighten the U-bolt, the pipe will tighten further, hence decreasing the bore size, this is the method i have used for my 12V and have had no problems, leaks etc..
|
philly willy
Member
Registered: 13th Jun 02
Location: DARLINGTON
User status: Offline
|
I didi the same except my back box was off a 1.4 simply cut two more slits into the pipe so it all nipped up. Worked a treat.
One word of advise though use a U bolt coz u can get a tighter hold, unlike with the bad.Also make sure ya postion ya u bolt in the right place or it will bang on the rear axle on Big bumps especially if ya moto is lowered
|
