scaron5188
Organiser: South West
Premium Member
Registered: 17th Apr 08
Location: Chippenham, Drives: arden 2.0 sport
User status: Offline
|
cheers mate, would be good lol. well the noise did start happening when the new pump was put in (2nd hand item) but when we changed the filter today it didnt make the noise. but still ran shit, but didnt cut out atall.
just can't think of anything else to try 
[Edited on 17-04-2009 by scaron5188]
|
steven_r2008
Member
Registered: 23rd May 08
Location: Nottingham
User status: Offline
|
the 'whining noise' youre talking about. is it when the car has been started from cold and goes once the car has warmend up a bit? if it is my car does the same thing and i just thought it was something to do with the automatic choke?
[Edited on 17-04-2009 by steven_r2008]
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
the car not chucking up any codes? And you said you've changed the cts and lambda... Vacume hose for the map sensor all ok? Im getting a little stumped.. Could possibly be fuel pump but wouldn't want to say that till the last thing.
|
scaron5188
Organiser: South West
Premium Member
Registered: 17th Apr 08
Location: Chippenham, Drives: arden 2.0 sport
User status: Offline
|
the cts and lambda were put on new before we got it. but mayb worth trying some different ones. haven't checked the map hose. we changed the fuel pump for one we brought off of here. sop dont know whether its worth chucking the old one on see what happens?
im a bit stumped to
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
Have you done the paperclip test yet to see if any codes are flashing up.
|
scaron5188
Organiser: South West
Premium Member
Registered: 17th Apr 08
Location: Chippenham, Drives: arden 2.0 sport
User status: Offline
|
yea, came up with fuel pump and crank shaft sensor. changed those already
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
put the cts off your other engine in it, and the lambda, then disconnect the battery for a hour and see what it does.. Will clear the codes stored, and will put the ecu into a form of learning mode that just checks everything is working right and does some quick set ups.. Then check codes again.. But dont forget to check the fuel tank vent valve hoses (side of inlet manifold 2 pipes into black box with red tab on connector) and the map sensor hope for perishing..
|
scaron5188
Organiser: South West
Premium Member
Registered: 17th Apr 08
Location: Chippenham, Drives: arden 2.0 sport
User status: Offline
|
will do this later bud and let u know how it goes.
cheers mate 
|
