andy hirst
Member
Registered: 18th Apr 02
Location: Rochdale, Greater Manchester
User status: Offline
|
Here is my new amp: Jensen XA2150 300w MAX 200W RMS Bridged
The questions are
1. To bridge which channels do i use
2. On the inputs, there is High, Low and Pass < WTF
3. Do i switch on the low or high pass when running a sub
I know its a cheap amp (30quid) but its going into my corsa which my girlfriend will be getting in 6 months, and i have a mint system planned for when i get my mk1 golf gti.
Thanks
Andy
[Edited on 12-09-2003 by soaped]
|
M4tt
Member
Registered: 18th Apr 03
Location: Potters Bar
User status: Offline
|
when running a sub you want it to be set to low pass.
there should be some info in your amp book about bridging, but usually it means putting the wires to the positive on the right channel and the the negative on the left channel. could be dif on your smp though.
|
andy hirst
Member
Registered: 18th Apr 02
Location: Rochdale, Greater Manchester
User status: Offline
|
its second hand, hence only 20quid. on the right neg and left plus there is a circle round the symbols. I am guessing that these are the bridged channels.
|