Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
something weirds going on with my temperature guage. when i start my corsa b the temp increases like normal, but after a while (about an hour or so) the needle slowly goes down and shows no temp. It's done this twice so far but i don't know what it is.
It started doing this after i ran a cold air feed to the induction kit, but i don't think it's got anything to do with that and it doen't happen all the time.
Does anyone know?
[Edited on 25-01-2004 by Mo]
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
no-one
|
MoNkEy MaGiC
Member
Registered: 12th Apr 03
Location: West - London Drives: Corsa GSi
User status: Offline
|
once my temp reading didnt work at all, turned out the clip on the wire to the sensor was loose n came of, check urs to see if its loose
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
cheers i will check that. anything else i should check if it's not that?
|
Mo
Member
Registered: 29th Jan 03
Location: Bolton, Drives Q3 S-line +
User status: Offline
|
ttt
|