PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
I've currently got the front of my car up on 2 bricks, as when I fitted the wheels & put it back on the floor, the hubs came off 
there are no drive-shafts in the hubs, they went with the engine, but they were a bit fooked anyway!
I've got 2 front strut assembly thingies with hubs attached in the garage, reckon if I swap them over they should be ok?
Adam-D says his was on wheels with no shafts in them, but i need to move my car to face the other way in the drive
wana get this done before it gets dark
cheers
|
Siberia
Member
Registered: 9th Oct 03
Location: Leprechaun Land Drives : Zafira GSI
User status: Offline
|
just make sure u have the bottom ball joints bolted on anf the anti roll bar and it should roll with no shafts
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
reet will give it a try then!
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
fcukin typical 
Just get the bumper off (pulled off), car jacked up, find a socket the right size & just start going at it to try undo the old bolts & it starts pissing it down
|
TOMAS
Member
Registered: 7th Aug 02
Location: Nottinghamshire
User status: Offline
|
Sitting a car on its wheels with no shafts through the hubs can fook the front bearings big style mate!
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
the whole front setup is gona be replaced anyways, so dont matter if the bearings get fooked!
|
