FrankP
Member
Registered: 12th Aug 02
Location: Melbourne, Australia Drives: 02 Barina SRi 1.8
User status: Offline
|
as above. I've looked thru the Corsa C TIS and there are only speed signals which don't work with my shift light.
|
corsa3.0v6
Member
Registered: 13th Jul 03
User status: Offline
|
think your goin 2 struggle there cos the engine control unit sends a signal to the body control module which then sends a signal to the instruments!! Goin to be a bit of a nightmare to work out.
|
FrankP
Member
Registered: 12th Aug 02
Location: Melbourne, Australia Drives: 02 Barina SRi 1.8
User status: Offline
|
You guessed correctly. I've been trying since last thurs to work it out. oh well guess my process of illimination continues. When i get the thing working i'll post a how to.
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
connect it directly to the oil pack and switch it to a 2cyl config on the shift light, only connect one of the -ve feeds from the coil.
|
FrankP
Member
Registered: 12th Aug 02
Location: Melbourne, Australia Drives: 02 Barina SRi 1.8
User status: Offline
|
it don't work like that.
www.rev-lite.com
[Edited on 11-05-2004 by FrankP]
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
3) tacho signal, usually from the negative terminal on your ignition coil. If you own a multi coil car you will only need to locate the tacho signal from your computer which will be avalible either from the wiring loom near the computer itself or from the ign power module
Yes it does, but unless you can switch it to 2cyl set up, you'll have fun connecting it.
|
FrankP
Member
Registered: 12th Aug 02
Location: Melbourne, Australia Drives: 02 Barina SRi 1.8
User status: Offline
|
yeah it's a multi coil but can't find the tacho signal, probed justabout every wire there was and nothin. I know the shift light is working coz i tried it on a car with a dizzy.
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
normally you'd find where the engine loom meets the car loom and look at th e9-pin plug for the green wire, btu if the corsa C doesn't have this setup then you'd need to connect the shiftlight to one of the -ve coil feeds, then switch it to 2cyl and it will work fine.
|
