kingkazi
Member
Registered: 27th Oct 03
Location: leicester
User status: Offline
|
im plannin on havin 2 10w3v2 D2 subs.
i know i can run both off a monoblock amp at 2ohms but will i be able to run them off a 2channel amp at 2ohms as well then? is that possible!!
cheers
|
drunkenfool
Member
Registered: 7th Feb 03
Location: Hereford Drives: Audi R8 V8
User status: Offline
|
what resistance are the subs, and are they single or dual voice coil?
|
kingkazi
Member
Registered: 27th Oct 03
Location: leicester
User status: Offline
|
dual voice coil
D2 stands for that i think
|
kingkazi
Member
Registered: 27th Oct 03
Location: leicester
User status: Offline
|
ttt
|
drunkenfool
Member
Registered: 7th Feb 03
Location: Hereford Drives: Audi R8 V8
User status: Offline
|
it should be possible, depending if the subs are wired in parallel or series. What is the power of the subs @ what resistance, and the same for the amp?
|
kingkazi
Member
Registered: 27th Oct 03
Location: leicester
User status: Offline
|
these are the specs i found of the JL 10w3v2 d2:
Nominal Diameter: 10 inches (250 mm)
Continuous Power Handling: 300 Watts
Voice Coil: 2.25" diameter, 4-layer, Kapton former
Available Configurations: Dual 2 ohm
Xmax (one-way, linear): 0.51"-0.58" (13.0-14.7 mm) depending on specific model
Sealed Enclosure Range: 0.60-0.90 cu.ft. (17.0-25.5 liters)
Ported Enclosure Range: 1.00-1.50 cu.ft. (28.3-42.0 liters)
VRC™ Technology: YES
Elevated Frame Technology: YES
iv not got any specific amp in mind at the momoent, just looking at alpine or phoenix gold amps but wanted to know if i can run em off a monoblock, can i run them both off a 2 channel amp then in parrallel etc?
cheers drunkenfool
|
kingkazi
Member
Registered: 27th Oct 03
Location: leicester
User status: Offline
|
ttt
|
cdcool1
Member
Registered: 9th Jun 02
Location: Scunny
User status: Offline
|
ok mate, they are Dual 2 ohm subs
running both off one amp
Monoblock options:
0.5 ohm stable amp (fairly rare!!)
2 ohm stable amp
2 channel options:
each channel 1 Ohm stable
each channel 4 Ohm stable
channels bridged and being half ohm stable (i doubt you'll find one of these!)
channels bridged and being 2 ohm stable
4 channel options:
bridge two sets of two channels, giving you effectively two channels, these need to be either 1 ohm or 4 ohm stable
They are all your realistic options mate
|