M2RTY
Member
Registered: 25th May 01
User status: Offline
|
any1 done this themselves without it sagging?
i take it you took it out first?
mart
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
Take it off.
Put on a few layers of impact adhesive to stop the glue soaking into the material - watered down PVA would work too.
Tick the trim on with impact adhesive - NOT spray adhesive.
|
M2RTY
Member
Registered: 25th May 01
User status: Offline
|
i used to use the brush on glue, much better then spray, never sealed one before trho! might give it a try
mines fucked, sagged in middle, dont know why tho and i dont want to mess a new 1 up
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
Yea, seal it up, because the glue soaks in too much... You'll find that the spray glue 'goes off' (yellow and crappy) and can't stick to stuff after a few months of getting hot e.t.c... If you used it to do your roof the first time round then that'll bed your problem...
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
i did my roof lining was a prper fooker to do but looks mint now its done
|
