corsa.dan
Member
Registered: 16th Nov 03
Location: Essex
User status: Offline
|
My mate has a pug 106 but we can not figure how to run the amp and power cables through the car can anyone help.
Dan
|
Mase
Premium Member
Registered: 16th Sep 01
Location: Derbyshire
User status: Offline
|
i've fitted an amp 2 a saxo before, id'a thought it would have been the same. On the saxo there was a large grommet under the brake master cylinder thing, an it comes out just above the carpet, under the glovebox. u then run it down the car by lifting the door seal, and getting a flat blade screw driver and taking off the carpet grippers, and the carpet should come up enough so u can route the cables !!!
Mase
|
Mikorsa16v
Member
Registered: 2nd Sep 02
Location: Burgess Hill, West Sussex
User status: Offline
|
had to drill a hole in my 206 and put a grommet in
|
Jamie
Member
Registered: 1st Apr 02
Location: Aberdeen
User status: Offline
|
On my Coupe I ran the power wire from the drivers side engine bay (where battery is) and just followed the wires that are there standard through the grommet
|
scott b
Member
Registered: 23rd May 04
Location: Woolston, Drives: Combo C
User status: Offline
|
look for a gromet in the bulkhead or where other wires go through and then push the wires under the trim.
RUN THE POWER CABLES ON 1 SIDE OF THE CAR AND PHONO LEADS ON THE OTHER SIDE.
stops interference
|