andrewww1
Member
Registered: 28th Oct 03
Location: Cumbria - www.lfc-forum.co.uk
User status: Offline
|
my corsa b 1993 lf only has a speo and i am looking to add a rev counter as well by buying a new panel.
Will this be easy?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
it may just be a straight swap... unplug old... plug in new, some peoples are some aren't
|
andrewww1
Member
Registered: 28th Oct 03
Location: Cumbria - www.lfc-forum.co.uk
User status: Offline
|
how comes some are different? is it easy to add a new wire?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
the wire is usually taped up if it doesnt swap straight over
|
andrewww1
Member
Registered: 28th Oct 03
Location: Cumbria - www.lfc-forum.co.uk
User status: Offline
|
cheers for the advice
|
Will94
Member
Registered: 1st Nov 02
Location: Nr. Ipswich, Suffolk
User status: Offline
|
if its a 1.4 then the wiring will already be there, jus get the right speedo drive (cable or electronic) and it'll b plug & play. If its a 1.2 then you will need to run a wire down to the green one in the 9-way multiplug near the ECU and connect this up to the relevant pin at the speedo/rev counter end.
|
dan.payne
Member
Registered: 19th Dec 03
Location: Whittington, Derbyshire
User status: Offline
|
My merit/swing already had the pea green wire on the plug at the top. so it was a straight swap.
|
Siberia
Member
Registered: 9th Oct 03
Location: Leprechaun Land Drives : Zafira GSI
User status: Offline
|
so did my 1.2 merit... it was just a case of out with the old clocks in with the new...
the wire is here on the plug
|
