paulszat
Member
Registered: 15th Aug 02
Location: Kent, UK
User status: Offline
|
I'm trying to fit electric window regulators and motors into my non electric corsa B doors. Have looked in the tutorial and I notice it mentions looking for 20 wires....I have 20 wires in the loom at the car side but I don't have the connector in the loom in the door to plug in to the motor.
My question is does anyone know which pin is which on the motor? If I can find out which colour wire goes to which pin I can wire it in myself!
Hope someone can help!
|
RKS
Member
Registered: 2nd Mar 04
Location: Gloucestershire UK
User status: Offline
|
your best bet is to get to your local scrappy and get the door looms from an electric window model, (saves alot of messing around, my leccy window kit came with looms
|
corsa_lover
Member
Registered: 2nd Feb 03
User status: Offline
|
made my own loom, you'll find:
brown = earth
black = ignition +ve
red = permanent +ve
blue/red = window up signal
grey/green = window down signal
each motor has 4 wires; live, earth, up and down. On both sides hard wire lives and earths for motors and switches. on drivers side connect up and down wires to your switch. On passengers side youll have to test the switch as it has 2 sets of up and down wires. 2 are outputs and 2 are inputs from the drivers side. connect the up and down wires from the passenger motor to the outputs and run the inputs to the drivers side, connect these to the passenger switch on the drivers side
Easy!! any probs u2u
|