X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Havent started the engine yet due to idle valve being off!
BUT, found another problem, where my loom drops through the bulk head, the seal has split, letting in water, took out the ECU and plug which had in it water, but not the ECU thank fcuk, just on the connector, i wd40'd down the crack in the loom seal in the bulk head, left the ecu on the boiler for an hour and wd'd all the ecu connectors!
Plugged her back in and no faults apart from the crank sensor, which does it when engine isnt running anyway!
Lets hope when i strike her up all is dandy, lets go get the ICV on and strike her up!
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
FIXED!
5 days of hell and sh'es back purring like a kitten!
YES YES YES YES!
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
 Good job lad...
|
Siberia
Member
Registered: 9th Oct 03
Location: Leprechaun Land Drives : Zafira GSI
User status: Offline
|
thank god.... well done! go drive! (dont crash  )
|
Matt.H
Member
Registered: 12th Mar 03
User status: Offline
|
nice to hear mate.
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Well it continues! I lost a bolt for my top mounts to secure my strut brace back on it went ping ping ping, then nothing and its not on the floor so i cant take it out tonight!
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
least the engine is ok
get some sealent round the hole so no water and get in again
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
I have, put some in and taped it up.
Does anyone know where the ABS 5 pin plug is so i can read the fault codes, i've traced the wires that come from the control modul in the engine, to the ABS ECU in the passenger foot well and around to the handbrake, now wondering if its on the drivers side near the bulge in the foot well...........anyone know!?
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
havent a clue.
gis a sec ill try and find out
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
according to my haynes the ecu is behind the kick panel on the passenger side
not sure if the plug is behind there too?
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
No, unfortunately its somewhere else! I've found the ECU in the kick panel, have a feeling its over the drivers side somwhere as there are a load of cable that come from the ECU, then unders the passenger seat and across over the handbrake area, i'll have a ganders tomorrow, cheers for looking though!
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
its in the fuse box same plug as engine management
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
quote:
Originally posted by J100RSA
its in the fuse box same plug as engine management
ahh! The 2 pins at the bottom? Opposite end to the ECU paperclip plugs?
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
i dunno i just plug my scanner in
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Well there are only 4 connectors in it, the top two for ECU, do you know if on your scanner there are 2 plugs at the bottom as well as the top?
[Edited on 20-04-2005 by X 60RSA]
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
I've given up, been up all night trying to solve this and still no joy, seems to be getting a voltage surge to my ABS and Alarm ECU from somewhere, about time i phoned the auto electricians.
|
