Kano
Member
Registered: 29th Aug 04
Location: Fife
User status: Offline
|
Been fitting my magnex decat 2day.. Had it all ftting fine, but now I cant the downpipe to decat joint to stop blowing. Seams to be sitting at a good angle and using a new gasket....
Any ideas?????
|
Stu
Member
Registered: 3rd May 00
Location: Madchester UK Drives: 2014 BMW M135i
User status: Offline
|
Sounds like there is crap on the CAT flange, both surfaces need to be totally flat!
If all else fails get some exhaust seal gunk, that usually sorts it!
|
Fraser Young
Member
Registered: 26th Dec 02
Location: Dundee City Drives: 58 Impreza WRX
User status: Offline
|
Replace springs n bolts at same time...
|
Kano
Member
Registered: 29th Aug 04
Location: Fife
User status: Offline
|
Aye am using new springs and bolts. Think its the surfaces not being flat causing it. Al give it another try 2moro... Cheers...
|
3CorsaMeal
Member
Registered: 11th Apr 02
User status: Offline
|
did you renew the o-ring?
i used firegum on mine too
|
Kano
Member
Registered: 29th Aug 04
Location: Fife
User status: Offline
|
Yeh got new bolts and o-ring with the decat... Gonna take it off at the join 2moro, rub down the downpipe surface and try again.. Had enough of it 2day.....
|