Wonderboy
Member
Registered: 30th Dec 06
Location: Ayrshire, Scotland
User status: Offline
|
Dam, just about to start her up and it snapped. It looks like a new clutch as well. Oh well, getting a new one coming tomorrow.
Is there anything other than wear and tear that could of caused it to snap ?
Also how hard is it to change ? I'll have a look in my Hyanes manual tonight.
[Edited on 24-02-2007 by Wonderboy]
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Quite easy change, just a bit fiddly.
Bad routing of the cable can cause it to snap
|
Wonderboy
Member
Registered: 30th Dec 06
Location: Ayrshire, Scotland
User status: Offline
|
Ok i have just fitted me new cable - hope the routing is ok.
The only thing i have left to do is clip it onto the pedal, i had it on put the pedal wouldn't fully go down because the metal end was catching.
Does the wire go underneith the little metal hook at the top of the pedal ?
|
Wonderboy
Member
Registered: 30th Dec 06
Location: Ayrshire, Scotland
User status: Offline
|
I just moved it so that i could push the pedal all the way down, and the cable came off the pedal, so thats not good.
How is it you get the cable to sit securley on the pedal ?
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
If its same as a nova.
You remove a spring clip out the end of the pedal, push the end of the cable(like a metal hook) through the hole.
Then the spring clip clips back in, which holds it.
|
davcohen
Member
Registered: 1st Nov 03
Location: North London
User status: Offline
|
fiddly but fairly straight forward
|