Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
I know in the past a few people have used fusion fabrications & they've done a really good job, but do they do full cages?
Really need one with door bars as my doors won't have any strength in them. Might be a bit dangerous if I get sideswiped or have a crash
So whats good/bad? What should I be paying? etc etc
Best I've seen so far is Bendys but I bet that cost a fortune
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
Fusion only do aluminium IIRC.
Is this for the white car?
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
http://www.adrenaline-race.com/accueil.html
http://www.racingdevelopments.com/
Bit far for you though
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Yes its for th white one
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
racing developments looks ace but as you said its a bit far which adds to the cost (and I get the impression that they aren't exactly the cheapest company to use)
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
IIRC, a rear half cage, exactly the same as jr's, is £350, so a FULL cage, well, I reckon about £800, if you have door bars and triangulation to the turrets through the bulkhead.
BUT, if you've seen broster's or jr's in the flesh, you'll see how good they are, I've not seen another cage sit so close to the pillars as Mark's.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
we now do full safety devices cages at Vsport can offer a 5% discount to CS members, maybe a bit more if a few people are interested. I am having one for project Vsport, come with lots of bar options and are either weld or bolt in.
If you are interested Matt just ring me at Vsport after 4pm tomorrow
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Weld in or bolt in Dave?
Oh & a rough figure?
|