kerzo
Member
Registered: 10th Nov 02
Location: Norn Iron
User status: Offline
|
I have been offered a set of 15 inch alloys off a mate that he used to have on his corsa. However they were on a clio before he got them and I am assuming that they are the wrong offset for a corsa. Would spacers put too much of a strain on teh bearings etc?
|
Makarus
Member
Registered: 25th Jun 02
Location: Nottingham/Derbyshire Boarder.
User status: Offline
|
They will be wrong, I am sure they are 110mm bolt set where as Corsa's are 100mm.
Dont know about the offset.
|
kerzo
Member
Registered: 10th Nov 02
Location: Norn Iron
User status: Offline
|
How did he actually have them on his corsa then? Is the pcd the diameter from the centre? Surely then the holes would be completely mis-aligned?
|
Kris TD
Member
Registered: 25th Mar 02
Location: Ware, Hertfordshire
User status: Offline
|
pcd on clio is the same as a corsa, i know this cos i bolted one ogf my 17's onto mates phase 1 clio yesturday.
clio is et 36-38 ideally, u donnt spacers, the need to move in, not out, u may get away with it on 15's, wouldnt on anything bigger though.
|
kerzo
Member
Registered: 10th Nov 02
Location: Norn Iron
User status: Offline
|
OK cheers kris
|
Kris TD
Member
Registered: 25th Mar 02
Location: Ware, Hertfordshire
User status: Offline
|
just remove the rear arch bolts, well the top 2 then u may be alright, depends on the car reeally, everyone seems to get different results.
|
kerzo
Member
Registered: 10th Nov 02
Location: Norn Iron
User status: Offline
|
Theres a good chance mine should be alright coz it was lowered 40mm on 17's before i bought it
|
