Redcorsa69
Member
Registered: 21st Sep 02
Location: Rotherham
User status: Offline
|
I think thats what the banging is. There is only a gap of about 40mm between the exhaust and trailing arm. Is there anything I can put between them to silence the noise?
|
Gambit
Member
Registered: 5th Jun 00
Location: Common Sense HQ
User status: Offline
|
aye gaffer tape a sponge to the trailing arm where its bangin
also turn the exhaust clamp 90 degree so that the bolts point horizontal
|
Redcorsa69
Member
Registered: 21st Sep 02
Location: Rotherham
User status: Offline
|
but won't that be a bit dangerous next to a hot exhaust?
|
Ojc
Member
Registered: 14th Nov 00
Location: Reading: Drives : Clio 197
User status: Offline
|
Just take the whole exhaust off, will stop the banging and will sound wicked.
|
Mikorsa16v
Member
Registered: 2nd Sep 02
Location: Burgess Hill, West Sussex
User status: Offline
|
lol, i had a sebby zaust put on and the retards at ripspeed (AA) couldnt fit it for shit, i had to take it to quick fit today to get it fitted properly, twats.
the clamp was turned round the wrong way and not done up properly, no new rubber mouts put on...blah
|
Gambit
Member
Registered: 5th Jun 00
Location: Common Sense HQ
User status: Offline
|
get some ford focus hangars for it,
and if your scared of the sponge going on fire then get some heat reflective gaffer tape
|
Ojc
Member
Registered: 14th Nov 00
Location: Reading: Drives : Clio 197
User status: Offline
|
If all else fails, go for sellotape.
|
Scott M
Member
Registered: 15th Feb 01
Location: Bexleyheath, Kent
User status: Offline
|
Or blu tak, thats fairly fire retardant.
|
Cybermonkey
Member
Registered: 22nd Sep 02
Location: Sydney, Australia
User status: Offline
|
Use Vectra exhaust clamps, they are a lot stronger and shorter.
Dave
|