LukeD
Member
Registered: 23rd Jan 07
Location: Shropshire
User status: Offline
|
Firstly i have very little knowledge within this area, so much help is needed from the pros!
I kinda thought that its best to use Vernier Pulleys with the Cams, is this true?/needed?
Also what duration profile is best to have on standard managment? 256 sound right?
And lastly- im looking at prices on this website below :
http://ebc-uk.com/frame-detail.asp?PAGE=/kent-cams.htm
Stupid question- but what is included in the Cam kit?, is this Cams and pulleys? or just ignore that and buy them seperate?, or is there anything else needed or advised to buy?
Im very confused anyway!
Cheers all! + (sorry for many questions)
[Edited on 16-02-2008 by LukeD]
[Edited on 17-02-2008 by LukeD]
|
gavin18787
Premium Member
Registered: 22nd Feb 05
Location: Basildon, Essex
User status: Offline
|
Check out the tutorials, dave a did a couple of good guides
256 isnt that different from standard, to 264 would be my choice
Cams will work without verniers but cannot be timed in perfectly without them. However unless you use Diablis verniers (with tabs for the cam sensor to read off) you will have to go for aftermarket managment.
Oh and when you by cams you just get the two cams
Hope that is of some help
Drives supercharged Tec with torque
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Standard is 244 if i remember rightly.
|
dean101287
Member
Registered: 22nd Jul 07
Location: Cardiff
User status: Offline
|
http://www.corsasport.co.uk/board/viewthread.php?tid=298969
|
LukeD
Member
Registered: 23rd Jan 07
Location: Shropshire
User status: Offline
|
helps alot.
So basically to run Cams, Vernier Pulleys are needed- and therefore a different engine managment.
But ive been looking at the Dbilas pulleys and Dbilas Cams (profile not stated on site), this can apparently run off standard managment. Does anyone have any experience/reccomend this product?
Im probably best to ring V-sport when ive got time in week!
|
Superlite Ltd.
Member
Registered: 9th Jan 07
User status: Offline
|
264 ftw
thats what i was going to have for mine
|
LukeD
Member
Registered: 23rd Jan 07
Location: Shropshire
User status: Offline
|
quote:
264 ftw
and where can i get these from?, plus they can be used with the dblias vernier pulleys right? or is it best to get the same make cams?
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
dbilas pullies will work with any cams
|
Scotty C
Member
Registered: 6th Nov 05
Location: Kidderminster Drives: 1.6 16v Sport
User status: Offline
|
Check newman's site, their cams are good & a reasonable price too.
You can mix and match any cam with any pullie.
|
LukeD
Member
Registered: 23rd Jan 07
Location: Shropshire
User status: Offline
|
Cheers guys!
|