Nathan570
Member
Registered: 21st Jul 08
User status: Offline
|
Its not that tricky to do, a haynes manual would tell you how to do it but its basicaly
Undoing the bolt on the outside
Removing trim on the inside of the boot u have to prise out the plugs.
Unclip the wireing from the motor think the wire is brown cant remember
Then undo the 2 bolts securing the motor
To sort out the big hole i just meshed it and covered it in fibre glass, sanded it and painted it 
[Edited on 29-07-2008 by Nathan570]
[Edited on 29-07-2008 by Nathan570]
|
