am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
ooo didnt notice the fog lights, how much did they cost and where di you find them?
|
ste_p23
Member
Registered: 29th Dec 08
Location: Hindley,Wigan
User status: Offline
|
they were 40quid from tom simes on here
|
am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
check the previous page too mate, wrote a longer message
[Edited on 06-05-2009 by am4nf]
|
ste_p23
Member
Registered: 29th Dec 08
Location: Hindley,Wigan
User status: Offline
|
i like my lights so end of really
|
Phil_b
Member
Registered: 31st Mar 08
Location: Wirral
User status: Offline
|
loving the back seats mate!
i fitted my janspeed 4-2-1 yesterday you will definately notice the difference
|
scaron5188
Organiser: South West Premium Member
Registered: 17th Apr 08
Location: Chippenham, Drives: arden 2.0 sport
User status: Offline
|
i got my replacement x16xe with a janspeed 4 2 1 and i noticed a difference higher up the revs, wana get an inlet to, will be wicked i reckon
good progress
|
am4nf
Member
Registered: 27th Jul 08
Location: South Ayrshire Drives: Corsa Sport
User status: Offline
|
i was talking about the splitter mate, and its just imo about the lights
|
ste_p23
Member
Registered: 29th Dec 08
Location: Hindley,Wigan
User status: Offline
|
Cheers guys and i have the inlet kit from flame so its gona be good fun when its all done
|
ste_p23
Member
Registered: 29th Dec 08
Location: Hindley,Wigan
User status: Offline
|
Hello just another update for you all.
My irmscher pedals are now on the car after some slight modifications As you can see below!
Now that the inside of the car is nearly done (Apart from waiting for a few carbon fibred parts back) i set to work building my boot build
The mesaurments of the boot where taken and then examined as seen below.
Then after a long graft a full wooden box was made that will sit level on the boot floor and my amp will go into with a viewing window and then my sub will sit on top of the box
The custom box
Then the box was sprayed with carpet adhesive and was carpeted as seen below
One this was done it was all wired up and dropped into the boot floor ready to be tested as shown below.
The next step is to wire up my subs and drop them in a box to but on top of my custom made box. The only problem is they are 15inch and there is two of them lmao :laugh:
Comments welcome!
|