luke1k
Member
Registered: 16th Apr 08
Location: Braintree, Essex
User status: Offline
|
Hi all,
I have put my calibra seats in my 1.4 sport.
The loom is there and i have put the buttons in but they don't seem heat up
Do i need to put a relay anywhere or a fuse anything like that? Or are they plug n play?
[Edited on 23-06-2009 by luke1k]
|
AlunJ
Member
Registered: 3rd Apr 07
Location: Newport
User status: Offline
|
I have no idea but I imagine you would be right in needing to add a fuse to the fuse board, had a look to see if there is any empty fuse holders that appear to be linked to a circuit? Like I say, i've never done it so I'm not positive but it's usually the case
|
SR91
Member
Registered: 21st Jun 08
Location: Lancashire.
User status: Offline
|
Yeah you'll need to fuse them You put switches in?
|
luke1k
Member
Registered: 16th Apr 08
Location: Braintree, Essex
User status: Offline
|
quote: Originally posted by SR-91
Yeah you'll need to fuse them You put switches in?
I have checked the fuse holder and filled the possible gaps in. The switches are in.
I left them on for a while to see if they got warm/hot and them seemed to stay at the same temperature.
I am half way though building the car at the moment so it has no ecu or none of the loom from the engine bay not sure if that would make a difference.
|
SR91
Member
Registered: 21st Jun 08
Location: Lancashire.
User status: Offline
|
You found the fucse number?, and look inside the fuse bit where the pins go, can you see two pieces of metal or is it just blank holes?
If its to empty blank holes you need to wire it into the look then into the fuse box, just like doing leccy windows...
|
Shane
Member
Registered: 10th Jan 04
User status: Offline
|
or the heater elements could be fucked
|