ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
basically rev it over 2k you will start to here a clattering noise, like piston slap you cant really tell where its come from on the engine, drives fine still, still pulls, took the rocker off check the top of the valve springs and everything is seated correctly. any ideas its on a 2litre 8v
|
SportBoy
Member
Registered: 5th Oct 01
Location: Retford, Nottinghamshire
User status: Offline
|
does it do it when its cold? or just when warm?
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
cold and warm
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
little ends...
|
gez bay
Member
Registered: 14th Feb 08
Location: South Wales drives: Vxr
User status: Offline
|
dont drive it around like that, just change the bottom end bearings, otherwise you'll need a new engine if the bearings go
[Edited on 29-06-2009 by gez c16b]
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
bearing are about 2 months old
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
could also be pre-ignition? what setup do you have?
|
ali_corsa
Member
Registered: 30th Jun 07
Location: Tamworth Drives: Focus st
User status: Offline
|
just 2 litre 8v bottom end using red top pistons, everything else is standard headwork. it ran fine since easter weekend till saturday night never let run low on oil, always checked weekly coolant level is fine
|