tom2k7
Member
Registered: 11th Dec 07
Location: Raunds
User status: Offline
|
hi i have giving my x16xe a full rebuild, started it up today for the 1st time and it runs but it ideals fine for about 10 secs then revs up 2 3000rpm on its own, i havent let it go any higher i jus killed it straight away, i have check everyting i can tink of but as u lot on here are corsa sport gurus i guess one of u will have the answer i need 2 solve my running probs
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
make sure all your vacuum pipes are correct
one to MAP sensor, one to FPR, one to fuel tank vent valve and one to rocker cover vent valve
|
tom2k7
Member
Registered: 11th Dec 07
Location: Raunds
User status: Offline
|
my m8 came down with his sport and i checked mine against and they are all gd but it still does it, sum1 said sumat about throttle body gaskets as i havent replaced them
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
yea if you havnt changed the gaskets between the upper and lower inlet manifolds chances are you have an air leak, get a new one and use some gasket sealant aswell
|
tom2k7
Member
Registered: 11th Dec 07
Location: Raunds
User status: Offline
|
i got a brand new one of but i will get sum gasket sealant
|
Craig P
Member
Registered: 9th Mar 08
Location: Carlisle,Cumbria
User status: Offline
|
Check the big black rubber thing that sits inbetween the TB & Top inlet manifold.When i rebuilt my Engine and started it up,It did the exact same thing and that was what my problem was.
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
Oops I just presumed it had a flame inlet on it!
You make sure the jubilee clips are tight on that rubber cylinder
|
