shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
the oil pressure switch on a calibra with ecotec lump cheers
|
scottyp1989
Member
Registered: 29th Jul 07
Location: Warley, West Midlands
User status: Offline
|
will be a 1/2 pn plug normally and im sure there on the back of the block, could be wrong tho
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
It's on the back of the block by the oil pump. It is a 2 pin sender and uses the same hole as the single pin switches.
|
shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
is it easy to get from the top of the engine
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
Not really. You may be able to remove it be touch but it's a 2 min job from under the car.
|
shauny bizzle
Member
Registered: 2nd Aug 06
Location: Sheppey, Kent Drives: Vectra GSI V6
User status: Offline
|
ok magic cheers people
|