Jake
Member
Registered: 24th Jan 05
User status: Offline
|
its nearly up to 3bar, ive bled a rad twice and it eventually creeps up again. It has no probs with central heating and hot water btw. Is there a permanent fix to this?
cheers
|
C2RL R
Member
Registered: 28th Mar 02
Location: Redcliffe, QLD
User status: Offline
|
i'm no plumber but i would guess that your filling loop is passing water. check that the valve is fully off. it could be that the filling loop is fucked and a little water is still entering the system and increasing the pressure. Matt will probably be along soon to point you in the right direction.
[Edited on 28-01-2010 by C2RL R]
[Edited on 28-01-2010 by C2RL R]
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
would you use the filling loop to raise pressure? my mums boyfriend was undoing a nut to raise the pressure, ive checked it and it wasnt fully tightened so ive nipped it up
|
C2RL R
Member
Registered: 28th Mar 02
Location: Redcliffe, QLD
User status: Offline
|
yes the filling loop put mains water into the system so if it is passing the pressure will raise slowly.
|
Jake
Member
Registered: 24th Jan 05
User status: Offline
|
probably sorted it now, ill bleed the rad again tomorrow and see how it goes. cheers
|
