8vcorsa
Member
Registered: 6th Dec 09
Location: Conwy
User status: Offline
|
i have taken off my x16xe corsa inlet manifold off and i just put it back on and it is reving too high can anyone help and need help fast
|
kristof1989
Member
Registered: 12th Jan 10
Location: West Sussex
User status: Offline
|
air leak..... possible a split in the rubber that goes from the alloy inlet that goes over top of engine to throttle body... mine split and it sat at about 4000rpm
|
8vcorsa
Member
Registered: 6th Dec 09
Location: Conwy
User status: Offline
|
its running fine now i think you were right i took it off again and put it back on and it ran fine abit of splutter to start it but its fine now and you know the yellow pipe that had a hole aswell i put instulation tape over that and the bit your on about i took a thing of it and that and i just put it bak on and i must of not had it on properly lol i know next time then lol
|
kristof1989
Member
Registered: 12th Jan 10
Location: West Sussex
User status: Offline
|
spot on
|