djbrowney
Member
Registered: 29th Nov 08
User status: Offline
|
All Located in Kings lynn
All plus postage
Collection welcome
Corsa Gsi rad with spal fan £50
(Good condition few bent fins)
Nova/corsa/tigra/astra/calibra Complete 5 stud setup
This little lot would cost you £300 plus All Brand new apart from caipers and backing plates. (all Came from Auto vaux) Cav v6 setup for hand break able at top on conversios.
£120
Disks
hubs (160 Alone)
stud conversion
both set of pads
adusters
calipers
springs
backing plates
Pad clips
Nova disk rear axel bare (shot blasted and powdercoated silver, rear anti roll bar and polly bushed)
£50
Nova disk hand break cables (new) £10
Corsa/Tigra Conversion Mounts £60
(3 bolt rear conversion and mount, front drivers side mount and conversion rubber)
c20xe powercap £60
(painted anthrasite)
Roose C20xe conversion Breather hoses £40
(3 Pieces set in blue set up for powercap, breather hoses have been cut as was runing a catch tank)
Roose C20xe coversion Ancillary hoses £100
(6 pieces set in blue)
Anti roll bar lowering blcoks £6
Momo steering wheel £50
T3 Flange £10
Stanley screw drivers £3 each
(these are between £7-£9 each)(some new, some used)
CK 1000v electriacl screw driver £15 the set
Stanley screwdriver 123 ph and pz set £10
Cd Flight case £25
(like new)
All for early round tooth belt setup
Only selling due to now need late type setup
All plus postage
Cam belt backing plate (shot blasted and powder coated black)
£25
QED steel crank pulley (loose wood ruff key)
£70
Cambelt kit £80
Water pump (metal Fins)
£35
Cambelt cover (cut out for verniers)
£25
big block inner cv joint Brand new £40
Vectra super touring wheels 16" stud (all 5 shot blasted and powdercoated white) (5 Brand new toyo t1r's fitted, one still to be fitted)
One has a very small fat spot which i was just going to use as a spare. Center caps included £400
20l high voltage purple 2k base £5 1 ltr
cesaro center cap £10 Dirty lol x2 ]
f28 thrust bearing 192 miles old £5
Fibre glass mk2 front wings, salon for extra arch clearance half the wight of standard ones £120
Part Machined hubs
£25 the lot
(there is nothing wrong with these they are half machined for converting to corsa/nova/tigra conversion) Were brand new before maching
Nova f28 Mount
(Has two extra holes in to alow to be drop lower on the mount)
£5
[Edited on 23-11-2010 by djbrowney]
[Edited on 23-11-2010 by djbrowney]
|
