john_redtop
Member
Registered: 31st Dec 08
Location: acklam middlesbrough
User status: Offline
|
is it possible to change them on a corsa b if so how hard is it to do with the engine in
[Edited on 19-07-2012 by john_redtop]
|
XE Col
Premium Member
Registered: 23rd May 10
Location: Rochdale, AKA:Boissy07
User status: Offline
|
The actual rack that goes to each wheel?
Don't think you will get it off with engine in
|
XE Col
Premium Member
Registered: 23rd May 10
Location: Rochdale, AKA:Boissy07
User status: Offline
|
Maybe wrong though depends on the clearance at back of engine. Need to disconnect from the column in the footwell and the ball joints on each end then 4 13mm nuts hold it in place, may just be able to persuade it out with engine in but I've never tried tbh
|
john_redtop
Member
Registered: 31st Dec 08
Location: acklam middlesbrough
User status: Offline
|
Is there no way of changeing the arm that the track rod end goes on instead of the full rack the nut that locks against track rod end was stuck tried getting it loose and snapped the arm
|
XE Col
Premium Member
Registered: 23rd May 10
Location: Rochdale, AKA:Boissy07
User status: Offline
|
not sure again never tried, but from remembering what the one looked like i just ripped off probably not
|
Corsa_Sport21
Member
Registered: 13th Apr 08
Location: Leven, Fife. Drives : 205 GTi
User status: Offline
|
Yes you can change the arms. They are just screwed into the steering rack.
Had to do it on Sc0ots old Corsa after he done the same, snapped the TRE.
|
john_redtop
Member
Registered: 31st Dec 08
Location: acklam middlesbrough
User status: Offline
|
Ok cheers I'll have to have a better look after we snapped it we just give in for the day lost all interest lol we had a quick look but couldn't see out
|
Nic Barnes
Member
Registered: 5th Apr 04
Location: nowhere near ginger people
User status: Offline
|
Yeah changed them on mine C20let in no dramas
|
nibnob21
Premium Member
Registered: 16th May 10
Location: South Derbyshire
User status: Offline
|
I think you're on about the track rods. In which case yes you can replace them individually. Shouldn't be too hard a job.
MX5 Project Thread
|
Mikey_j
Member
Registered: 1st Nov 08
Location: Ipswich
User status: Offline
|
Pull the boot back and its just screwed into the rack
|