davegreen
Premium Member
Registered: 20th May 12
Location: Oxfordshire
User status: Offline
|
looks like the start of a good project! you doing anything to the bottom end of the engine? raising comp ratio arp bolts steel rods? if not you best not run that rev limit!
|
gan1992
Member
Registered: 7th Jun 12
Location: Mey, Highland
User status: Offline
|
havent quite thot about that yet,haha mite have to be a track only car haha
|
gan1992
Member
Registered: 7th Jun 12
Location: Mey, Highland
User status: Offline
|
that was jst a joke pic. the rev limiter is set at 7800 so getting arp bolts and would like to get hi comp pistons but moneys running low atm
|