jay.jay
Member
Registered: 28th Dec 10
Location: Gloucestershire
User status: Offline
|
Does anyone know anywhere that makes the mounts for a c20let into a corsa c? There's not a lot of information regarding this conversion on the web as I gather it's not too common. I know M tec do a lot but it's 1900euros 😳
Also any other advice from any one who's done the conversion would be great 👍
|
davegreen
Premium Member
Registered: 20th May 12
Location: Oxfordshire
User status: Offline
|
as the c20 and z20 share the same block can't you use them mounts?
its not that common because the c20 is an old engine now, hard to find a good one and ecu does not support canbus so you need to piggyback standard ecu in order to get dash to work. or go fully standalone.
|
jay.jay
Member
Registered: 28th Dec 10
Location: Gloucestershire
User status: Offline
|
Are the c20 and z20 blocks exactly the same in terms of mounting then? I always thought they were different but I could well be wrong. I'm currently rebuilding the c20let at the minute so seems a waste not to use it. As for the wiring it shouldn't be too difficult to piggyback the original ecu to get the clocks working etc
|
davegreen
Premium Member
Registered: 20th May 12
Location: Oxfordshire
User status: Offline
|
i know of people using x20xev blocks in both c20 and z20 cars, and c20 in z20's so the casting must be the same on the out side.
you may need a different cam belt cover as the mount is on the end of the block for astra g/corsa c
|
davegreen
Premium Member
Registered: 20th May 12
Location: Oxfordshire
User status: Offline
|
i know of people using x20xev blocks in both c20 and z20 cars, and c20 in z20's so the casting must be the same on the out side.
you may need a different cam belt cover as the mount is on the end of the block for astra g/corsa c
|
