-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
or do i have to wait till the 2 litre is in????
|
J100RSA
Member
Registered: 4th Mar 01
Location: Thornhill, West Yorkshire
User status: Offline
|
Yes but revcounter reads wrong
|
3CorsaMeal
Member
Registered: 11th Apr 02
User status: Offline
|
yeah, but u'll only need two digits 
|
J da Silva
Member
Registered: 10th Apr 03
Location: The FACTory
User status: Offline
|
quote:
Originally posted by 3CorsaMeal
yeah, but u'll only need two digits
just read your other post about 1litre centrepipes, your on a mission arent ya mate
|
3CorsaMeal
Member
Registered: 11th Apr 02
User status: Offline
|
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
dickhead
|
Dave
Member
Registered: 26th Feb 01
Location: Lancs
User status: Offline
|
quote:
Originally posted by J100RSA
Yes but revcounter reads wrong
This is true, it will over read by a mile.
I fitted a set of clocks out of a 1.4 16v and the rev counter went right round past 7k
Something to do with 3 cylinders instead of 4, I'm too tired to remember what though.
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
Yes i know this happens on normal clocks with rev counters.
However, seen as it is possible to get a rev counter reading correctly on a 12V (3 cylinder) , then i see no real problem why the digi shouldnt with a little bit of help.
Could be my next mission 
|
Dave
Member
Registered: 26th Feb 01
Location: Lancs
User status: Offline
|
Some 12v come with rev counters as standard, mine did.
As far as I know these are the only ones that are accurate as they count 3 pulses per revolution.
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
Yes, as does mine at the moment.
I should hopefully be able to transfer the wiring and so on from my original rev counter, onto a digi dash.......... and fingers crossed i'll have the first full working digi dashed 3 cylinder engine
Something to be proud of
|
