topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
Just fitted my Gmax -40mm suspension kit, front is proper low as on tyre but back is only bout 10-20mm lower? this normal? or should i put -60mm springs on back?
also Cosworth bonnet vents are they a go? or a no go? i quite like em but just want some opinions (constructive)
and finally,
Team dynamic speed 8's in 16" ET 45, can anywhere get em? no where (PVD, Scotts tyres, TMC's etc) can get em anymore around me?
thanks
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
springs take about a month to settle dude, get some big ice or a couple or paving slabs inthe boot to speed things up lol, i got 60mm kit by g-max it dropped 70ish inthe end, i would say get 60mm anyway
Oh and if ya used ya original bump stops on the rear check the car aint sitting on these holding it up, sometimes they need trimming down
[Edited on 01-07-2004 by Greasemonkey]
|
PaulW
Member
Registered: 26th Jan 03
Location: Atherton, Greater Manchester
User status: Offline
|
same with my spax kit, was a 50-80mm drop up front (adjustable) and fixed 60 at rear, but once it all settled, rear went to about 70mm & front would drop to 100mm (i was even sad enough to measure it against a ruler)
|
topshot_2k
Banned
Registered: 1st Dec 03
Location: Northampton Drives: Pug GTi-6
User status: Offline
|
yea bumpstops done, it is on 14" rims at mo so hopefully new 16's will make the rear look abit better.
anyone got any thorts on vents then?
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
personally i aint a fan or bonnet vents the only ones i like are the subtle ones by cool lourves, they stamp them into ya bonnet
|
